Badlands 2.3L w/o sway/stay-bar disconnect - Transmission pan protection

Bronco Beachin 207
Nov 16, 2026

Rank II

Yesterday at 4:47 pm

Any ideas for protecting the plastic transmission pan?

I’ve got the 2.3L (automatic) without the sway-bar disconnect and the factory badlands bash plates. Having trouble finding a transmission pan skid that will fit.

Would it be better/easier to swap to a new pan?

Attachments

‘26 Bronco Badlands, 2.3L, 4-door, MIC hardtop, non-SAS, marsh gray. Southern Maine.

Gladesmen

Yesterday at 10:06 pm

#1
Any ideas for protecting the plastic transmission pan?

I’ve got the 2.3L (automatic) without the sway-bar disconnect and the factory badlands bash plates. Having trouble finding a transmission pan skid that will fit.

Would it be better/easier to swap to a new pan?

You must have a newer Badlands, since the Swaybar Disco was Standard in earlier models. These guys are great People and they wheel their Bronco. https://talonsgarage.com/products/f...n-skid-plate-2022-2025?variant=46564215357748

As far as replacing the transmission Pan I have the PPE pan but have yet to install it because the bolts behind the Exhaust pipe were a PITA and I ran out of time to fart around with them.
BN 1100, Desert Sand Everglades. Reservation 7/30/20. ordered 1/22/21, reordered 10/15/21 dropped tow and hard top, reordered 3/9/22 changed to Everglades. production date 9/7/22 rescheduled 9/14/22 completed 9/26/22, shipped 10/7/22, arrived 10/31/22, delivered 11/03/22

Rank II

Yesterday at 10:20 pm

#2
You must have a newer Badlands, since the Swaybar Disco was Standard in earlier models. These guys are great People and they wheel their Bronco. https://talonsgarage.com/products/f...n-skid-plate-2022-2025?variant=46564215357748

As far as replacing the transmission Pan I have the PPE pan but have yet to install it because the bolts behind the Exhaust pipe were a PITA and I ran out of time to fart around with them.

Thanks…

Yes I have a ‘26. From what I’m told it’s been made an option in the newer models. I didn’t know squat when I purchased, else I probably would have sprung for it. I bought off the lot too, so it’s what was available. I used the disconnect at the off-Roadeo, but honestly not too sure how much I’d use it in real life.

Is that talon plate pretty simple to install? Does it matter that I don’t need the disco disconnect part of it? Do any of the factory plates need modifications? I thought I watched a video where something had to be cut. Might have been something else, I’ve been researching the crap out of it. Haha.

Yeah I’m not really very mechanically inclined. Nor do I have a lift/lot of tools. I was looking for the easiest protection for the buck/best practice. Heard a few stories of trail damage and I’m in the “an ounce of prevention is worth a pound of cure,” school.

A new pan involves draining/refilling fluid and a gasket? Not sure if I could handle that or not.
‘26 Bronco Badlands, 2.3L, 4-door, MIC hardtop, non-SAS, marsh gray. Southern Maine.

You must log in or register to post here.