Drivers Window Issue

edpanz7
Jun 07, 2026

Rank I

Jun 07, 2026

2026 Bronco with 2K miles on it, came out of the store today and window was down, when try to put it back up it hits the top and then automatically goes back down. Got it all the way up to seal but then does not lower down when you open or close the door.

Rank 0

Jun 07, 2026

#1
This may help... not sure if your window is up or down, but here is the "complete" reset procedure, if it is able to move at all.

Window Reset Procedure
Carry out all steps within 30 seconds of starting the sequence.
1) Close the window.
2) Press and hold the window control switch until the window is fully open. Keep the window control switch pressed for two seconds.
3) Lift and hold the window control switch until the window is fully closed. Keep the window control switch held for two seconds.
4) Press and hold the window control switch until the window is fully open. Keep the window control switch pressed for a two seconds.
5) Lift and hold the window control switch until the window is fully closed. Keep the window control switch held for a two seconds.
Nminus1, Stryf

Rank I

Jun 07, 2026

#2
Thank you. Will give it a try.
24GTbadlands

Rank V

Jun 08, 2026

#3
2026 Bronco with 2K miles on it, came out of the store today and window was down, when try to put it back up it hits the top and then automatically goes back down. Got it all the way up to seal but then does not lower down when you open or close the door.
Hi there. I’d like to assist with your concern. Could you please send us a DM with your VIN and mileage so I can look into this further?

Rank I

Jun 08, 2026

#4
I have the same issue and tried the reset procedures Stryf, Unicorn provided, but no luck. Issue still exists.

Rank V

Jun 09, 2026

#5
I have the same issue and tried the reset procedures Stryf, Unicorn provided, but no luck. Issue still exists.

Hey there. I’d like to assist with your concern. Could you please send us a DM with some more information so I can look into this further?

You must log in or register to post here.