The Bronco Nation’s how-to expert Jon Melton of Nashville Early Bronco is back again, and this time to show you how to install Rock Slide Engineering’s tailgate table on your 6th gen Bronco.
We love the RSE step sliders on our Bronco, and another favorite product of ours is their tailgate table. It’s sturdy. It’s a double-decker. It has functional design elements like a bottle opener and trash bag holder. It’s easy to install, and it does. not. rattle.
Watch the video below to see how simple it is to add to your Bronco’s tailgate. Don’t forget, Bronco Nation members get 10% off all Rock Slide Engineering Bronco products … and we fully believe you’ll like them as much as we have so far.
How To: Tailgate Table Installation
You’ll need a Phillips screwdriver, drill, and 1/8” bit. A center punch and hammer are also useful.
- Start by marking the bottom middle hole first (use the center punch to make a dimple if you’d like), then drill it out.
- Install the tailgate using just this bottom middle hole.
- Mark the remaining five holes (ignoring the three larger holes), then drill these out.
- Lift the tailgate table in place, screw in the six screws, and you’re done!
Member Discount
If you have questions about your member discount or need a refresher on what the code is, email us at [email protected]. Not yet a member? Join us.
Comments
You must log in or register to post here.