Nudge bar for '24 BD w/factory bumper

If it helps your internet searching... the bumper you have is commonly referred to as the "capable bumper".

The three Bronco bumpers:

• Plastic bumper, aka: molded-in-color bumper
• Capable bumper, aka: steel bumper
• Heavy-Duty Modular Bumper

I also have the capable bumper on my Badlands and completely took it apart to install a winch. My hunch, based on that experience, is any solution you find will probably have to drill into the bumper itself.

Thanks man, my Bronco has the plastic bumper but it has the hanging tow hooks from the bumper as opposed to the hooks attached to the bash plate. The only nut bar I could find on rough country, which I purchased, required bolting into the tow hooks located below, so it would not work on my vehicle

rankinS1

Thanks man, my Bronco has the plastic bumper but it has the hanging tow hooks from the bumper as opposed to the hooks attached to the bash plate. The only nut bar I could find on rough country, which I purchased, required bolting into the tow hooks located below, so it would not work on my vehicle

Yeah that's the problem you're going to have, the only real location to bolt onto that bumper is the same spot where the tow hooks are.

Also... is the entire bumper plastic or does it just have plastic trim pieces on it?? The capable bumper with the hanging tow hooks is powder-coated steel with some plastic trim pieces on it. (Here is my bumper for reference, feel free to jump around, it's a long video.)

If yours is all-plastic that implies that there is a new bumper out in the wild that I was completely unaware of.